   |
|
 |
Plant Tour Electromech Technologies |
 |
|
| The Educational Society for Resource Management Wichita Chapter 71 |
May 2000 |
| Newsletter Editor: Elly Love, CPIM | Elly@accessgroupllc.com |
|
|
|
|
|
Plant Tour Electromech Technologies |
|
|
| The Educational Society for Resource Management Wichita Chapter 71 |
May 2000 |
| Newsletter Editor: Elly Love, CPIM | Elly@accessgroupllc.com |
|
|
  |
Electromech Technologies, founded in 1968, is a custom design and manufacturing facility specializing in electromechanical equipment including AC and DC motors, centrifugal and axial blowers, rotary and linear actuators, motor operated valves, generators, and electronics for the Aerospace and Defense industries. Electromech Technologies has the design, testing, manufacturing, and overhaul capabilities to meet virtually all original equipment and after-market aerospace and defense specifications. They are dedicated to be responsive, cost-competitive, and customer driven. Electromech Technologies generates $21 Million in sales, employs 180, and has 40,000 square feet dedicated to manufacturing. They carry out machining, fabrication, and assembly. They are an FAA approved repair station. In June 1999, Electomech Technologies became a part of the Mckechnie family of companies. Mckechnie is an international engineering group with worldwide interests in the design, development and manufacture of specialist engineering components, engineered plastics, and consumer products. The tour will have a "shotgun" start. This means that everyone will begin the tour at the same time, but from different starting locations. With this logistic, everyone will start and end the tour at about the same time. It is very important to be on time so that you get the entire tour.
|
||
| May Tour | . | . | |
| Date: | Tuesday, May 9th, 2000 | ||
| Time: | 6:20 PM | ||
 |
 |
 |
|
| Location: Electromech Technologies 2600 S. Custer |
|||
| Reservations: | |||
| For capacity planning purposes, reservations need to be phoned to Roger Klocke, (316) 522-4981 #221, no later than noon, Friday, May 5. There is no charge for the tour. Dinner will not be provided. | |||
|
|
|
|
|
|||
 |
|||
| THIS IS THE DATE FOR THE MAY PLANT TOUR ELECTROMECH TECHNOLOGIES HAS INVITED US TO TOUR THEIR FACILITY AT 2600 S. CUSTER. |
|||
 |
|||
| D I R E C T I O N S | |||
| From the West: Take Kellogg to the West Street exit. Go south 1 1/2 miles to Pawnee. (This is a tricky intersection because Southwest Blvd. crosses West Street just North of Seneca. Go past the Southwest Blvd. stop light to get to Pawnee.) Turn left (East) on Pawnee then go 2/3 mile to Custer. Turn right (South) and go 3/4 mile to Electromech. |
From the East: Take Kellogg West to the Meridian exit. Take Meridian South to Pawnee then turn right (West) about 1/3 mile to Custer. Turn left (South) 3/4 mile to Electromech. |
||
| From the South: Take I-35 to I-235 West to the Meridian Exit, then North to Pawnee. Turn West and go about 1/3 mile to Custer, then left (South) 3/4 mile to Electromech. |
From the North: Take I-135 to Kellogg West and follow the directions above from the east. |
||
| . | |||
 |
|||
 1 2 3 4 5 6 7 8 9  |
|||